BMW 4 Series F32 (2014+)

AeroCatch Racing Hood and Body Panel Fasteners (Pair) - Better than h...

T#:340098

Part#: AEROCATCH

In Stock

$ 566.99

This product was last offered at the strikethrough price on
05-13-2026

Starting at $ 82.99 USD

Add to Wish List

Starting at $ 82.99 USD

Add to Wish List

As used by Turner Motorsport on our championship winning BMW race cars, the new aerodynamically efficient and aesthetically styled AeroCatch is setting new standards in hood fixing for the 21st century. Say goodbye to your standard hood pins -- these are better all around.

Show More Show Less

MAP Sensor

T#:39329317

Part#: 13628644432

In Stock

$ 110.00

This product was last offered at the strikethrough price on
08-12-2026

$ 100.99 USD

Add to Wish List

Qty

$ 100.99 USD

Add to Wish List

The manifold absolute pressure sensor (MAP sensor) is one of the sensors used in your N55 engine's electronic control system. The manifold absolute pressure sensor provides instantaneous manifold pressure information to the engine's electronic control unit (ECU/DME). The data is used to calculate air density and determine the engine's air mass flow rate, which in turn determines the required fuel metering for optimum combustion, efficiency, and ignition timing.

Show More Show Less

Vitesco Technologies MAP Sensor - BMW N20 N26 S55 S63

T#:39059260

Part#: 13627843531

In Stock

$ 93.99

This product was last offered at the strikethrough price on
06-28-2026

$ 90.99 USD

Add to Wish List

Qty

$ 90.99 USD

Add to Wish List

This is a replacement Manifold Absolute Pressure sensor Located on the charge air cooler. The MAP controls the amount of fuel that goes through the injectors based on the pressure of air at the intake manifold. If your vehicle is giving you a MAP code, replace it immediately to ensure you get the best gas mileage and performance. It is common for this part to fail slowly and cause poor fuel mileage and hampered performance. When it fails, the vehicle will stutter and stall as it falls into a limp mode. One way to check if your MAP is bad is to unplug the connector before starting your car. If it idles well (compared to a previous poor idle), your MAP sensor likely needs to be replaced. If you let this maintenance part go, your fuel economy will suffer as too much fuel is going into the engine and not being burned. A great way to give your vehicle an efficiency boost.

Show More Show Less